1/8" 24V AC Electric Brass Solenoid Valve
Availability: In Stock
Technical Details
SKU
RSSM-2-24VAC
Position
Normally Closed
Port Size
1/8" Female NPT
Voltage
24V AC
Body Material
Brass
Components
Stainless Steel
Seal Material
Viton®
Orifice Size
2 mm
Temp Range
5 to 250° F
Pressure Range
0 - 145 PSI (No Minimum)
Flow Rate
Cv 0.12 (Appx 0.9 GPM @ 60 PSI)
Power
10 VA
Coil Connection
Lead Wires
Coil Class
Class F (311°F)
Protection Class
IP65
Response Time
Fast Acting (Less than one second)
Duty Cycle
100% Duty at Rated Ambient Temperature
*Suitable Media
Water – Air - Fuel - *Etc
Weight
10.58 oz
Height
2.62"
Length
1.60" port to port
Width
1.20"
Product Overview
The RSSM-2-24VAC is our most compact 24 Volt AC Brass Solenoid Valve. This valve has a 1/8” female inlet and outlet port. It’s normally closed, meaning the valve remains closed until it's powered. Once powered, the valve will open almost instantly. Its response time is fast; in fact, it’s less than one second. Its low-power AC coil requires 10 watts of power to operate. The valve is compatible with a wide array of media types and temperatures ranging from 5°F to 250°F. The internal components feature SS304 parts and a copper shading ring. It has no minimum operating pressure and can perform up to 145 PSI.
The RSSM-2-24VAC solenoid valve is one of the smallest brass valves we offer. It has a solid brass body with 1/8” Female NPT input and outlet ports. The body features threaded mounting holes at the bottom for a neater installation. The valve's seal is FKM, or better known as Viton, and 316 stainless steel internal components, which are suitable for a range of media types. This unit is compatible with air, water, gas, fuels, diesel, weak acids, and many other chemicals. We advise you to refer to a chemical compatibility chart to be certain the valve will be suitable for your project.
The 24 Volt AC coil requires 10 watts of AC power to open the valve. Its normal position is closed, and the valve will return to this position when power is removed. The coil includes 5.5” lead wires that can be connected with your own choice of terminals. The coil is encapsulated, making it resistant to water and dust; however, it should never be submerged.
Its small opening of 2 mm makes it unsuitable for gravity feed systems, and it is not recommended. We recommend a pre-filter be installed to keep the valve free from debris and properly functioning.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
