1-1/2" 24V AC Electric Solenoid Valve N/O
Availability: In Stock
Technical Details
SKU
BZW-40K-24VAC
Position
Normally Open
Port Size
1-1/2" Female NPT
Voltage
24V AC
Body Material
Brass
Components
Stainless Steel
Seal Material
Viton® Diaphragm
Orifice Size
40 mm
Temp Range
15 to 250° F / -10 to 120°C
Pressure Range
Water: 0-90 PSI | Air 7-90 PSI
Flow Rate
Cv 29 (Appx 220 GPM @ 60 PSI)
Power
23 VA / 1.00 Amps
Coil Connection
DIN 43650A
Response Time
Fast Acting (Less than one second)
Duty Cycle
100% Duty at Rated Ambient Temperature
*Suitable Media
Water – Air - Fuel - *Etc
Weight
5 lbs 3 oz
Height
6.60"
Length
4.33" port to port
Width
3.35"
Product Overview
If you're searching for a Normally Open Solenoid Valve with 1-1/2" Female NPT ports that operates on 24 Volt AC power, then this may be the one. This valve is fitted with a Viton® seal that is compatible with a wide array of media types such as air, water, weak acids, fuel, and Freon. This particular valve can work with low-viscosity fluids below 20 cSt.
This valve is unidirectional and allows media to flow in a single direction. The orifice size for this valve is 40 mm. The valve has a Cv value of 29, which can be used to calculate the flow rate of the valve. Since the valve is normally open, it is in its ‘open’ configuration without power, and in its ‘closed’ configuration when powered. This AC valve's coil is rated at 23 VA and draws 1.00 Amps to function. The response time is also extremely fast, being less than one second.
Installation
This valve is perfect for a gravity feed installation since it requires no minimum pressure to operate. The maximum operating pressure for this valve is 90 PSI, and it has a temperature range between 15 and 250 degrees Fahrenheit. We always recommend using a pre-filter with diaphragm-type solenoid valves to keep the body free from debris.
The electrical enclosure for the valve has an IP54 rating, allowing for limited protection against dust and splash water from any direction. Since the coil has no polarity, the lead wires are interchangeable.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
