1/2" 12V DC Stainless Electric Solenoid Valve
Availability: In Stock
Technical Details
SKU
SZW-15-12VDC
Position
Normally Closed
Port Size
1/2" Female NPT
Voltage
12V DC
Body Material
Stainless Steel
Components
Stainless Steel
Seal Material
Viton® Diaphragm
Orifice Size
15 mm
Temp Range
15 to 250° F | -10 to 120°C
Pressure Range
0 to 90 psi
Flow Rate
Cv 3.5 (Appx 27 GPM @ 60 PSI)
Power
16 W | 1.50 Amps
Coil Connection
Lead Wires
Response Time
Fast Acting (Less than one second)
Duty Cycle
100% Duty at Rated Ambient Temperature
Suitable Media
Water – Air - Fuel
Weight
1 lb 6 oz
Height
4.00"
Length
2.36 " port to port
Width
1.80"
Product Overview
The SZW-15-12VDC is a 12 Volt DC, 2-way, 1/2" Stainless Steel electric solenoid valve that can be used for liquid, water, gas, diesel fuel, and air in a variety of different applications. This two-way, N/C valve will remain closed until power is applied and will remain open until power is removed. This valve has standard Female NPT ports on both ends. A 12 Volt DC power supply is required for operation, similar to the battery in most vehicles.
The SZW-15-12VDC stainless steel solenoid valve is fitted with a 16 Watt DC coil. This DC coil requires DC power to function and will work when connected directly to most vehicles' 12 Volt DC power. The coil is rated for a 100% duty cycle but not indefinitely.
The Viton seal makes this valve suitable for a wide range of fluids. This valve is rated for temperatures ranging from 15°F up to 250°F. It will operate at up to 90 psi and has no minimum pressure requirements, making it a great choice for a gravity-fed system.
Common Applications
- The stainless steel components are food-grade and make it a great choice when working with potable water or other food and beverages.
Installation
- Its mounting is preferred coil-up, but it will work in any position.
- A pre-filter is always recommended to keep the diaphragm free from debris and the valve functioning properly.
- There are two lead wires that can be joined with terminal connectors or directly soldered. These wires are interchangeable as the valve has no polarity, making installation simple.
*Consult a chemical compatibility expert for the correct seal and valve body.
