2-Piece Stainless Steel Manual Ball Valve - 1/4" up to 3" NPT
Technical Details
Product Overview
2-piece stainless steel manual ball valves are among the most commonly used types of manual ball valves, popular for applications with manual on/off flow control that is simple and easy to use. These valves are vital for many automated systems as they allow the system to be shut off for routine maintenance.
2-Way Full Port Valves
The BV-2PC-20-S series is our Stainless Steel 2-piece manual ball valve line. As the name implies, these valves are composed of two pieces of Stainless Steel that meet at a single joint. By manufacturing the valve with two pieces rather than one, a larger ball is able to be fitted inside the body, allowing the inside of the valve to have the same diameter as that of the piping it is connected to. This is referred to as “Full Bore” or “Full Port” and ensures there is no pressure drop or change in flow rate as media passes through the valve.
Our BV-2PC-20-S series comes standard with Female NPT threading and is available from ¼” all the way up to 3” in size, all of which have full bore openings. Contrary to our solenoid and motorized ball valve lines, these manual valves can be opened and closed to different degrees and come standard with a lockable handle lever that locks the valve in place when fully open or closed.
SS Valve Body
These valves all have PTFE seals, which, along with the 304 stainless steel body, make this valve type an excellent general-use valve for anything from water to gases or corrosive chemicals*, along with applications that use high heat. This valve is rated for temperatures ranging from -4° F to 356° F and pressure up to 1000 psi.
Common Applications
These valves are perfect for:
- Brewing systems
- Irrigation
- HVAC
- Industrial applications
- General purpose
Installation
- Shut off the system and relieve all pressure in the piping before installing the valve.
- Verify that the valve size and female NPT connections match the piping.
- Clean pipe threads and apply a compatible thread sealant or PTFE thread tape suitable for the media and operating conditions.
- Install the valve in either flow direction. This ball valve supports bidirectional flow, so there is no required inlet or outlet.
- Use a wrench on the valve connection when tightening. Avoid using the handle to turn or tighten the valve into the piping.
- Support the connected piping to prevent excessive stress on the valve body and threaded connections.
- Once installed, slowly pressurize the system and check all threaded connections for leaks.
- Turn the handle 90 degrees to open or close the valve. Align the handle with the pipe for open and position it perpendicular to the pipe for closed.
*Use our interactive chemical compatibility chart to quickly check if the media running through your system is compatible with stainless steel.



