Coils for 3/8" up to 3/4" Solenoid Valves w/DIN
Availability: In Stock
Technical Details
SKU
410
Protection Class
NEMA 4 / IP65
DIN Connection Type
43650A / PG11 Cable Grip
Power
AC 20VA / DC 20W
Valve Position
Normally Closed or Open
Compatible With
BCM, BZW, SZW and PSL Series
Fits
3/8", 1/2", 3/4" Solenoid Valves
Product Overview
Replacement coils for the BCM, BZW, PSL, and SZW series valves from 3/8" up to 3/4".
Note: These are intended for the valves we sell and are not to be used with any other valves or for any other purpose.
Details:
- The coil can be quickly connected and disconnected with the convenience of a 43650A DIN connector.
- Encapsulated IP65 / NEMA 4 enclosure type is ideal for outdoor use as well as spray-down locations.
WARNING: Never connect a coil to power without it first being securely fastened to a solenoid valve. Doing so can cause damage to the system as well as bodily harm.
Wiring Instructions:
- Loosen and remove the Phillips-head screw securing the DIN connector to the coil.
- Detach the DIN connector from the coil.
- Open the DIN connector housing by prying at the small slot located in the bottom corner next to the Earth terminal.
- Inside the housing, locate the screw terminals:
- Terminal 1: Connect the hot or positive wire.
- Terminal 2: Connect the neutral or negative wire.
- Earth Terminal (for AC voltages only): Connect the ground or Earth wire.
- Ensure all screw terminals are securely tightened for a reliable connection.
- Reassemble the DIN connector by reversing the steps above.
