Coils for 3/8" up to 3/4" Solenoid Valves w/DIN
Availability: In Stock
Technical Details
SKU
410
Protection Class
NEMA 4 / IP65
DIN Connection Type
43650A / PG11 Cable Grip
Power
AC 20VA / DC 20W
Valve Position
Normally Closed or Open
Compatible With
BCM, BZW, SZW and PSL Series
Fits
3/8", 1/2", 3/4" Solenoid Valves
Product Overview
Replacement coils for the BCM, BZW, PSL and SZW series valves from 3/8" up to 3/4". Intended for the valves we sell and not to be used with any other valves or for any other purpose.
The coil can be quickly connected and disconnected with the convenience of a 43560A DIN connector.
Encapsulated IP65 / NEMA 4 enclosure type are ideal for outdoor use as well as spray down locations.
WARNING: Never connect a coil to power without it first being securely fastened to a solenoid valve. Doing so can cause damage to the system as well as bodily harm.
Wiring Instructions:
- Loosen and remove the Phillips-head screw securing the DIN connector to the coil.
- Detach the DIN connector from the coil.
- Open the DIN connector housing by prying at the small slot located in the bottom corner next to the Earth terminal.
- Inside the housing, locate the screw terminals:
- Terminal 1: Connect the hot or positive wire.
- Terminal 2: Connect the neutral or negative wire.
- Earth Terminal (for AC voltages only): Connect the ground or Earth wire.
- Ensure all screw terminals are securely tightened for a reliable connection.
- Reassemble the DIN connector by reversing the steps above.
