1-1/2" 24V AC Stainless Steel Solenoid Valve N/O
Availability: In Stock
Technical Details
SKU
SZW-40K-24VAC
Position
Normally Open
Port Size
1-1/2" Female NPT
Voltage
24V AC
Body Material
Stainless Steel
Components
Stainless Steel
Seal Material
Viton® Diaphragm
Orifice Size
40 mm
Temp Range
15 to 250° F | -10 to 120°C
Pressure Range
Water: 0-90 PSI | Air 7-90 PSI
Flow Rate
Cv 29 (Appx 220 GPM @ 60 PSI)
Power
23 VA | 1.00 Amps
Coil Connection
DIN 43650A
Response Time
Fast Acting (Less than one second)
Duty Cycle
100% Duty at Rated Ambient Temperature
*Suitable Media
Water – Air - Fuel - *Etc
Weight
5 lb 1 oz
Height
6.60"
Length
4.50" port to port
Width
3.35"
Product Overview
Featured here is a 1-1/2" Normally Open 24 Volt AC Solenoid Valve. This particular valve is a two-way, semi-direct diaphragm valve with a normally open operating position. This means that the valve remains in the open position, allowing flow; once power is supplied, the valve will quickly switch into the closed position, preventing flow. The valve is uni-directional and will only control flow in a single direction. The valve is perfect for an automation project requiring the control of media. This large port valve has a 40mm orifice, which allows a substantial amount of flow over similar valves. Its suitable pressure range is from 0 to 90 PSI, making it great when a gravity flow valve is needed in a low- or no-pressure system. This valve is recommended to work within an ambient temperature range between 15 and 250°F or -10 to 120°C
The solenoid valve body is molded from 304 stainless steel, which is lead-free and food-grade. The diaphragm used to seal the valve is composed of FKM or Viton. The internal components are stainless steel. This valve's combination of body and internal components makes it suitable for a wide range of chemicals and gases, including but not limited to air, water, gasoline, diesel fuel, weak acids, glycol, as well as many more.
Installation
- The solenoid coil is included and can be wired via the valve's 3-prong DIN connector.
- The DIN connector is pre-wired and has no polarity, so installation can be done quickly.
- The valve will require 1.75 amps from a 24 Volt AC power source.
- The coil is shielded and splash-resistant with a NEMA 3 equivalent.
- It should never be installed in a wet location.
- Installation with the coil facing in the up position is preferred.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
