1/2'' 3 Way, 2 Position Pneumatic Solenoid Valve
Technical Details
Product Overview
The 3V410-15 series pneumatic directional control valve is a reliable component designed for precise control in pneumatic systems. It is a 1/2" 3-Way, 2-Position Pneumatic Direction Control Valve with a single solenoid control and air return function.
The 3V410-15 valve features a 3-way, 2-position design. The three ports are all 1/2" Female NPT threaded ports, which are widely used in the USA and on American-made pneumatic components. NPT (National Pipe Thread) ports offer convenience and compatibility with a range of pneumatic fittings commonly found in the USA. The use of NPT ports eliminates the need for adapters or conversions when integrating the valve into existing pneumatic systems.
All three ports are labeled by laser etching on the face, labeled as follows:
- P for the inlet or pressure port
- A for the outlet
- R for the exhaust.
When powered, the valve operates in the P to A position. When the power is removed, it opens to the A to R position, allowing the pressure to exhaust.
The 3V410-15 valve features an air return function for reset. This is necessary due to its larger 1/2" size, as the air volume required for an air return function to effectively reset the valve becomes significantly higher. As a result, the spring return function is more suitable and ensures reliable and efficient reset capabilities for the 1/2" size.
The 3V410-15 valve is built with durable materials, including aluminum alloy and NBR O-rings, to withstand demanding environments. This makes it suitable for any industrial application where precise pneumatic control is essential.
As with all of our valves, this valve adheres to ISO9001 standards during manufacturing. It is designed to fit seamlessly into existing manifold setups by conforming to standard industry sizes. The valve shifts in under 0.05 seconds. Coils should never be swapped; AC valves should only use AC coils and DC valves only DC coils.



Wiring Instructions:
- Loosen and remove the Phillips-head screw securing the DIN connector to the coil.
- Detach the DIN connector from the coil.
- Open the DIN connector housing by prying at the small slot located in the bottom corner next to the Earth terminal.
- Inside the housing, locate the screw terminals:
- Terminal 1: Connect the hot or positive wire.
- Terminal 2: Connect the neutral or negative wire.
- Earth Terminal (for AC voltages only): Connect the ground or Earth wire.
- Ensure all screw terminals are securely tightened for a reliable connection.
- Reassemble the DIN connector by reversing the steps above.
