1/8" 12V DC Electric Brass Solenoid Valve
Availability: In Stock
Technical Details
SKU
RSSM-2-12VDC
Position
Normally Closed
Port Size
1/8" Female NPT
Voltage
12V DC
Body Material
Brass
Components
Stainless Steel
Seal Material
Viton®
Orifice Size
2 mm
Temp Range
5 to 250°F
Pressure Range
0 - 115 PSI (No Minimum)
Flow Rate
Cv 0.12 (Appx 0.9 GPM @ 60 PSI)
Power
8 Watts
Coil Connection
Lead Wires
Coil Class
Class F (311°F)
Protection Class
IP65
Response Time
Fast Acting (Less than one second)
Duty Cycle
100% Duty at Rated Ambient Temperature
*Suitable Media
Water – Air - Fuel - *Etc
Weight
10.58 oz
Height
2.62"
Length
1.60" port to port
Width
1.20"
Product Overview
The RSSM-2-12VDC is our smallest 12 Volt DC Brass valve. This is a 2-way direct-acting valve configured in a Normally Closed position. A N/C valve will remain in its closed position and only open when power is applied. This particular valve requires 8 watts from a DC power source to function. Its operating pressure is recommended between 0 – 115 PSI.
It features a Viton seal, which is very versatile across many media types such as air, gases, water, diesel fuel, weak acids, and other low-viscosity fluids. It has a solid brass body and encapsulated coil. The internal components feature SS304 parts and a copper shading ring. It can withstand media temperatures as low as 5°F and up to 250°F.
This is a fast-acting valve that will open in under 1 second. The recommended operating pressure is between 0 and 115 psi. There is no minimum pressure required, but the valve is not capable of full flow with a gravity feed due to its small 2 mm orifice size. The flow rate of this valve can be calculated with its 0.2 Cv value.
Installation
- It requires 8 watts from a DC power source such as a standard automotive battery.
- Its coil is encapsulated and resistant to water and dust, rated IP65.
- The coil has 5.5” lead wires that can be connected directly to the power source. These wires have no polarity and can be interchanged with the positive (+) and negative (–) leads.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
