2" 110V AC Stainless Steel Solenoid Valve
Availability: In Stock
Technical Details
SKU
SZW-50-110VAC
Position
Normally Closed
Port Size
2" Female NPT
Voltage
110V AC
Body Material
Stainless Steel
Components
Stainless Steel
Seal Material
Viton® Diaphragm
Orifice Size
50 mm
Temp Range
15 to 250° F | -10 to 120°C
Pressure Range
0 to 145 psi
Flow Rate
Cv 48 (Appx 370 GPM @ 60 PSI)
Power
35 VA | 0.35 Amps
Coil Connection
Lead Wires
Response Time
Fast Acting (Less than one second)
Duty Cycle
100% Duty at Rated Ambient Temperature
Suitable Media
Water – Air - Fuel
Weight
6 lb 3 oz
Height
6.50"
Length
5.51" port to port
Width
4.25"
Product Overview
The SZW-50-110VAC is a fast-acting, normally closed 2-way solenoid valve with 2” female NPT input and output ports, a type 304 stainless steel valve body, and a 110-volt AC coil. Featuring a Viton diaphragm that resists heat, oils, and chemicals, this valve is suitable for use with air, fuel, water, and potable water, including food-grade applications. Acceptable operating temperatures are between 15°F and 250°F. There is no minimum operating pressure, but the maximum operating pressure is 145 psi. There is no minimum pressure needed to open or close the valve.
The SZW-50-110VAC is one of our largest capacity solenoid-operated valves. Whether opening or closing, it takes less than one second for this fast-acting 2” valve to operate. The valve is normally closed and equipped with a 110 volt AC coil that draws just 0.35 Amps of current. Although rated for continuous service, the solenoid should be powered down on occasion. With a voltage tolerance of ± 10%, this valve is compatible with most 120 volt AC residential and commercial power systems.
When the semi-direct lift valve is in the open position, the orifice size is 50 mm. This provides an approximate flow of 345 gpm at 60 psi, representative of a Cv of 48. The overall weight of the valve and solenoid is 6 lbs, 9 oz. Its length is 5.51” from port to port, height is 6.50”, and width is 4.25”.
Common Applications
- The valve’s 304 stainless steel construction, complemented by a Viton diaphragm, makes it well suited for use with potable water systems as well as other applications, including those requiring food-grade equipment.
- This also makes it compatible with a range of fluids including air, gas, water, diesel fuel, glycol, and weak acids.
Installation
- It can be mounted in any orientation.
- The threaded input and output connections are both 2” female NPT.
- Use of an inline filter is always recommended with solenoid-operated valves to ensure proper valve seating.
- Electrical connections are made using the 5.5” long lead wires.
*Consult a chemical compatibility expert for the correct seal and valve body material choice.
